- Home
- Pool Services
Our services
Pool Maintenance & Renovation Services
Already have a pool? We look after it cleaning, maintenance, renovation and equipment, lighting and feature upgrades.

Pool Cleaning & Maintenance
Regular cleaning, chemical balancing and pump and filter servicing.
Details
Pool Renovation
Bring an old pool back to life leaks, waterproofing, tiles and upgrades.
Details
Pool Lighting & Electrical
Underwater LED lighting, control panels and smart systems, safely installed.
Details
Filtration, Sanitation & Heating
Filters, pumps, salt or chlorine sanitation and heating systems.
Details
Jacuzzi, Waterfalls & Fountains
Adding jacuzzis, waterfalls and fountains to new or existing pools.
DetailsHow it works
Contact us
WhatsApp us or fill in the form and tell us what you need.
Free site visit
We visit and our engineer inspects the site and sets priorities.
Quote & schedule
You get an itemised quote and a clear timeline.
Build & handover
We deliver under engineering supervision and hand over with the warranty.
Caring for an existing pool, from upkeep to renovation
Common pool problems and what causes them
Most problems in an existing pool show a clear sign, and the sign points to where the inspection should start. This table links what you see to the likely cause and the service that fixes it.
| What you see | Likely cause | Where to look |
|---|---|---|
| Green water | Low chlorine or not enough filtration | Cleaning and maintenance |
| Cloudy water | Filter needs a backwash or pH is off | Filtration and sanitation |
| White crust on tiles | Scale from hard water | Cleaning and maintenance |
| Steady water loss | Leak in the shell, pipes or tank | Renovation |
| Tiles falling off | Failed adhesive or water behind the tiles | Renovation |
| A light that will not come on | Lamp, connection or water inside the fitting | Lighting and electrical |
| Loud pump | Air in the line or worn bearings | Filtration and sanitation |
The table is a starting point. The real cause shows up in the inspection. Green water, for example, can come from a pump running too few hours rather than from low chlorine.
What a maintenance visit covers
A maintenance visit is more than vacuuming the floor. We follow the same steps every time so nothing is missed.
- Skim leaves and debris off the surface.
- Empty the skimmer and pump baskets.
- Brush walls, steps and the corners where algae gathers.
- Vacuum the floor.
- Test and adjust chlorine and pH.
- Read the filter pressure and backwash if it has risen.
- Listen to the pump and check the plant room for leaks.
- Note anything that needs your attention.
We aim to hold the water inside well known ranges. For home pools that usually means pH between 7.2 and 7.6 and free chlorine between 1 and 3 parts per million. In that window the water stays clear, the chlorine works properly and the equipment is not strained.
Weekly or monthly contract
We offer weekly or monthly maintenance contracts covering cleaning, water balance and equipment checks. Which one suits you depends on the pool and how it is used.
| Situation | Usually best |
|---|---|
| Heavy use through summer | Weekly |
| Trees nearby or lots of dust | Weekly |
| Covered pool, light use | Monthly, with some checks by you |
| Villa or farm left empty for long periods | Set by location and time away |
| Hotel or compound pool | Agreed regular visits with a report |
A contract does not stop you looking after the pool between visits. We show you how to empty the baskets and read a test kit, so you notice changes early.
Seasonal care
A pool in summer is a different job from a pool in winter, and maintenance has to shift with the weather.
In summer the sun burns off chlorine quickly, heat helps algae grow, evaporation concentrates salts and use goes up. The filter needs longer run times and chlorine needs testing more often. On dusty, windy days debris builds up and baskets clog faster.
In winter use drops but the pool does not stop. Still water turns green even in the cold. We shorten run times and ease off sanitation without switching it off, and if there is heating we make sure it works before the cold sets in.
Spring and autumn, with their calmer weather, are the right time for renovation or equipment upgrades before the swimming season returns.
Upgrading equipment without demolition
Many older pools have a sound shell but equipment from another generation. The pump eats power, the filter does not clean well and halogen lights keep failing. All of that can be upgraded without touching the structure.
- A variable speed pump that runs to demand instead of flat out all day.
- A filter sized properly for the volume of the pool.
- A move from manual chlorine to a salt system or automatic feeder.
- Low voltage LED fittings in place of old lamps.
- A control panel with timers or phone control.
- Heating to stretch the swimming season.
Before recommending any upgrade we inspect the existing pipework, because a new pump on narrow or damaged pipes will not deliver what you expect. Lighting upgrades are covered on pool lighting and electrical.
Evaporation or a leak
Every pool loses some water to evaporation, more so in summer and on windy days. The question is whether the loss is normal. A well known bucket test lets you check before calling anyone.
- Fill a bucket with pool water and stand it on the first or second step so it sits at pool temperature.
- Mark the water level inside the bucket and the pool level on the outside of the bucket.
- Keep the pump on its usual schedule and keep everyone out of the pool.
- After a day or two, compare the drop in the bucket with the drop in the pool.
If both fall by about the same amount, it is evaporation. If the pool drops clearly more than the bucket, there is probably a leak. Repeating the test with the pump off narrows it down. A bigger loss with the pump running points to the return line, and a loss with the pump off points to the shell or suction line. The test does not pinpoint the leak, but it gives us a clear starting point for the inspection.
When a pool needs renovation
Maintenance keeps a pool going, but there comes a point where it is not enough. These signs say it is time to renovate.
- Steady water loss after you have ruled out evaporation.
- Tiles loose in several places, or sounding hollow when tapped.
- Cracks in the walls, floor or around the steps.
- Damp or flaking paint on a nearby wall or in the plant room.
- Broken or uneven copings.
- A dated design you want to change, such as turning a skimmer pool into an overflow.
Renovation starts with an inspection to locate the leak. Then we drain the pool, remove failed tiles, repair cracks and waterproof again, with a fill test before new tiles go on. We usually renew the lighting and pipework while the pool is empty. Details are on pool renovation.
Additions for an existing pool
If the pool is sound and you want to give it new life, several features can be added to an existing pool.
A jacuzzi can sit inside the pool in a corner or beside it, slightly raised so its water spills into the pool. A waterfall can run down a wall behind the pool or from a raised edge. Small fountains fit on the coping or into the deck. Each one needs its own pump or water line and space in the plant room.
Before starting we check three things. Is there enough room? Can the existing pipework cope? Is there enough electrical capacity for the new equipment? If not, we tell you what is needed first. See jacuzzi, waterfalls and fountains.
Regional conditions and after renovation care
We look after existing pools in every region of the Kingdom, and each region has its usual problem. In Riyadh and Najd it is dust and heat. On the west coast humid, salty air corrodes metal parts and fittings. In the east, groundwater and humidity can push water into older pools from outside. In the southern highlands the cold makes heating part of routine care. The full list is on service areas.
After renovation the pool needs a careful start. In the first days after filling we watch the water more closely, because new tiles and grout affect pH, and we clean the filter more often to clear dust from the works. From then on, regular maintenance protects the new work. Balanced water protects the grout, a clean filter eases the load on the pump, and spotting any water loss early keeps small problems small.
Our work carries a written warranty on workmanship and waterproofing. If you have a question, send photos of your pool on WhatsApp through the contact page, or browse all our services.
FAQ
What should I do if the water suddenly turns green?
Why is there a white line on the tiles at water level?
Can I maintain the pool myself?
My pool is old and I dislike the design. Do I have to demolish it?
Do I need to be home during maintenance visits?
How often should a pool be cleaned?
My pool loses water, leak or evaporation?
Is underwater lighting safe?
Is salt better than chlorine?
Can I add a jacuzzi to an existing pool?
How much does a pool cost?
Is the site visit really free?
Free site visit
Request a free quote
Fill in your details and WhatsApp opens with a ready message to our team to arrange your site visit.